Step 1
For better visibility you can change the EGT bar height by pressing the SEL knob and rotating it to
set the desired height. Pressing the SEL knob a second time allows you to adjust the leaning target
(set to 50 deg F below peak EGT from the factory). Press SEL a third time to save your
adjustments.
Step 2
It is a good idea to make check Probe Diagnostic page part of your flight check.
All green is good to go and red means there is a probe problem.
Best to spot a problem on ground rather than on rotation on take-off.
Left Engine
Right Engine
To Next Page
Loading...
