Insignia ES Series - Steam Generator Connections

www.insigniashowers.com Last Modied: 05/02/2021
22
The steam generator has 3 connecons.
1. Steam Outlet: Connect the white insulated hose to the tri-jet steam system within your shower as
shown in image A. Make sure these are ed in the correct posion as they are only aached for
transportaon reasons only.
2. Water Inlet: When installing the water line for the steam generator, there are 3 opons available:
• Install a stac water line from the shower valve (middle feed) to the steam generator.
• Purchase Insignia’s WRAS approved braided hoses, however, you may require a male to male connector to
connect them together to make them long enough depending on your shower model (screwx code: 71087)
• Purchase a female blanking cap (screwx code: 21851) which ts over the shower valve centre feed and
plumb a stac line directly from the cold in to the steam generator water inlet.
3. Drain: Connect the grey rubber hose from the steam generators drain opening to the nozzle on the
shower waste as shown in image B. Secure in place with the use of the Jubilee clip (AMI01) found in
your screw pack Ensure you drill out the spigot to allow the steam generator water to drain in to the
waste.
Steam Generator Connections (steam version only)
NOTE: MUST DRILL OUT
2
1
3
White Insulated Pipe
Steam Outlet
A
B
Steam
Generator