www.insigniaproducts.com
21
3-in-1 TV Stand
STEP 6: Option 1 - Mounting brackets on a TV with a flat back
You need:
1 Insert the selected bolts through the washers and correct mounting holes on the TV brackets (J), then finger tighten
them into the threaded holes on the back of your TV. Make sure that the TV brackets are centered and level with each
other and that the hooks face the bottom of the TV.
2 Tighten the bolts until they are snug against the TV brackets using a Phillips screwdriver. DO NOT over tighten.
Note: Lean the TV up against a wall or other solid surface when attaching with the TV brackets. DO NOT place the TV
face down on the glass. This may cause permanent damage.
Phillips screwdriver
Level
J TV bracket (2)
AA M4 × 12 mm
bolt (4)
CC M5 × 12 mm
bolt (4)
EE M6 × 12 mm
bolt (4)
GG M8 × 16 mm
bolt (4)
HH M8 × 20 mm
bolt (4)
Bolts and Washers
or or or or
KK Lock washer
M4 (4)
LL Lock washer
M5 (4)
MM Lock washer
M6 (4)
NN Lock washer
M8 (4)
QQ Flat washer
M4/M5 (4)
RR Flat washer
M6/M8 (4)
or or or or
QQ RR
KK LL MM NN
AA CC EE GG HH
To Next Page
Loading...
