Insignia NS-HFTVS3N175 - Mount Frame to Block or Concrete Wall

www.insigniaproducts.com
30
STEP 4: Option 2- Mount the frame to a block or concrete wall
You need:
1 Place the mounting frame (I) against the wall where you intend to mount the TV. Use a level to make sure that the
mounting frame is level, then mark the four mounting holes on the wall. Remove the mounting frame.
2 Drill four 7/16" (11 mm) holes through the screw marks to a depth of 2.5" (64 mm) using a drill with a 7/16" masonry
drill bit.
3 Insert a concrete anchor (T) into each of the screw holes using a hammer.
4 Align the mounting frame over the concrete anchors.
5 Place a washer (U) over one of the mounting frame screw holes, then insert a lag bolt (S) and tighten.
6 Repeat the previous step for the other three screw holes.
CAUTION: Never locate the mounting holes into the mortar between blocks. The TV may fall causing damage or
injury.
CAUTION: Make sure that the lag bolts are tight and secure, but do not overtighten them.
Power drill
Edge-to-edge
stud finder
Hammer
Pencil
Level
Socket wrench
7/16” masonry drill bit
S Lag bolt (4)
U Large flat washer (4)
T Concrete anchor (4)
2.5"
(64 mm)
(11 mm)
.4"