V1 ENGLISH 16-0306
PREPARING YOUR HEATER
1 Remove your heater from the package and place it on a
level surface, such as a desktop or the oor.
2 Plug the power cord into a standard 120V wall outlet.
3 On the back of your heater, press in the side of the
power switch. Your heater goes into standby mode and °F
appears on the display panel.
TURNING YOUR HEATER ON OR OFF
1 Press to turn on the front of your heater. The heater and
fan turn on.
2 Press again to turn o (standby mode) your heater.
NOTE: To test the tip over protection, pick up your heater while it's
operating. Your heater and the LED should both turn o. Put your
heater down and the LED should turn on. If you want to turn on the
heater, press .
SETTING THE TEMPERATURE
You can adjust the temperature between 50° ~ 95°F
(10° ~ 35°C).
1 Press the to select fan, low, or high mode.
2 Press + or – to increase or decrease the temperature. The
temperature setting ashes for 5 seconds, then lights solid.
Your setting is saved.
NOTE: Your heater may switch between Fan, Low, and High modes
to maintain the temperature you selected. For example, if you set the
temperature 3° above the room temperature, you heater works in
Low mode. If you set the temperature 6° or more above the room
temperature, your heater works in High mode. Otherwise, you heater
works in Fan mode.
SETTING THE TIMER
You can set the timer to turn o your heater after a specied
time (between 1 ~ 8 hours).
1 Press . The clock icon turns on.
2 Press to select from 1 to 8 hours. The timer setting ashes
for 5 seconds, then lights solid. Your setting is saved.
3 To turn o the timer before it expires, press until 0H is
displayed.
CLEANING YOUR HEATER
Important: Your heater has no user-serviceable parts. Do not disassemble. This will
void your warranty. Unplug the heater before you attempt to clean it.
• Clean your heater with a soft cloth, moistened with water. Do not use chemical
cleaners. Allow to dry thoroughly before using.
• Vacuum the air intake grill with your vacuum’s brush attachment every few weeks,
for optimal performance.
TROUBLESHOOTING
• If the heater isn’t working, make sure that it’s plugged in and that the power
outlet is providing power. Check your household circuit breaker/ground fault
interrupter, and reset if necessary.
• Make sure that the power cord is in good condition. If the cord is cut or frayed, do
not use the heater until you have it repaired.
• If the heater runs repeatedly for several minutes and then shuts o, clean your
heater.
SPECIFICATIONS
ONEYEAR LIMITED WARRANTY
For complete warranty, visit www.insigniaproducts.com.
CONTACT INSIGNIA
For customer service, call 1-877-467-4289
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2016 Best Buy. All rights reserved.
Made in China
Description
Model No.
Voltage/Frequency
Power
Frequency
Output Power
Product size
Product weight
Mini heater
NS-HTCBK7
120V AC
1500W
60Hz
1500W
9.6 x 6.5 x 6.2 in.
(24.5 x 16.5 x 15.7 cm)
3.6 lbs (1.6 kg)
Low
High
Fan
Neither
indicator is lit
Left indicator
is lit
Both indicators
are lit
NS-HTCBK7_16-0306_QSG_V1_EN.ai 2 6/7/2016 9:04:19 AMNS-HTCBK7_16-0306_QSG_V1_EN.ai 2 6/7/2016 9:04:19 AM
To Previous Page
Loading...
