Setup method C: Code search
1 Turn on your target device.
2 Press and hold SETUP until your
remote’s LED blinks twice.
3 Press
TELEVISION or
CABLE / SATELLITE /
STREAMING, or
BLURAY/
DVD to select the mode you want
to set up. The LED stays lit.
4 Press either 0 (for cable/satellite/
streaming), 1 (for TVs), or 2 (for
Blu-ray/DVD) to select the device
type you want to set up.
5 While pointing the remote toward
your target device, press and hold
OK until your device turns o .
Release the key when your device
turns o . Setup for that device is
complete.
LEARNING FUNCTIONS
FROM ANOTHER REMOTE
You can learn any function from your
original (working) remote control.
Creating a learned function
1 Make sure that your remote is
programmed to the device you
want to control. See “Programming
your remote.”
2 Place your original and new
remotes on a table with their IR
sensors 1-2" apart.
3 With your new remote, press and
hold SETUP until the LED blinks
twice.
4 With your new remote, press 9, 7, 5.
5 With your new remote, press
TELEVISION or
CABLE /
SATELLITE / STREAMING, or
BLURAY/DVD for the device
you want to learn a function from.
6 With your new remote, press the
button you want to add a function to.
The LED blinks continuously.
Note: Functions cannot be assigned to
the setup key or the three device keys.
To Next Page
Loading...
Need help?
General
