EasyManua.ls Logo

InSinkErator HWT300 - Final Installation and Operation Notes; Blinking Power Button Troubleshooting; Initial Heating Cycle Information

InSinkErator HWT300
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
ENGLISH
ESPAÑOL
FRANÇAIS
NOTICE:
Property Damage. Tank must be
located within 15.7” (400 mm) of dispenser
and within 30” (760 mm) or less of a
standard earth (grounded) outlet. DO NOT
extend plumbing or electrical lines.
*
AVISO:
Daños materiales. El depósito
se debe ubicar a 400 mm (15.7 pulgadas)
del dispensador y a 760 mm (30 pulgadas)
o menos del tomacorriente estándar con
conexión a tierra (descarga a tierra). NO
extienda tuberías o líneas eléctricas.
*
AVIS :
dommages matériels. Le réservoir
doit se trouver à une distance de 400
mm (15,7 po) ou moins du robinet et à une
distance de 760 mm (30 po) ou moins d’une
prise standard mise à la terre. N’utilisez
AUCUNE rallonge pour les conduites de
plomberie ou les ls électriques.
*
12
6
1
4
11
210
48
57
39
15
!
*
16
17
16
ENGLISH
ESPAÑOL
FRANÇAIS
!
19
:03
18
Note: Water will be cold at rst. Allow
12-15 minutes for water to reach target
temperature. Gurgling or hissing is normal
during the initial heating cycle.
IF POWER BUTTON BLINKS TWICE,
UNPLUG THE TANK AND REPEAT
STEPS 15-17.
!
SI EL BOTÓN DE ENCENDIDO PARPADEA
DOS VECES, DESENCHUFE EL DEPÓSITO
Y REPITA LOS PASOS 15 AL 17.
Nota: El agua estará fría al inicio. Deje
transcurrir 12 a 15 minutos para que el
agua alcance la temperatura deseada.
Es normal que se oigan ruidos sibilantes
o de borboteo durante el ciclo de
calentamiento inicial.
!
SI LE BOUTON DE MISE SOUS TENSION
CLIGNOTE DEUX FOIS, DÉBRANCHEZ
LE RÉSERVOIR ET RÉPÉTEZ LES
ÉTAPES 15 À 17.
Remarque : l’eau sera froide au début.
Allouez de 12 à 15 minutes pour que
l’eau atteigne la température désirée.
les gargouillements ou les sifements
sont normaux durant le cycle de
chauffage initial.
!

Related product manuals