Insitu 3DR Solo User Manual (English)

To Next Page

6. From Inexa Control, click on the home icon and then

click Network Explorer.

5. Launch INEXA Control 2.1.1 program

1. Ensure your 3DR Solo is running the latest 3DR officially

released software and firmware. This is done via following

manufacturer’s instructions to update using the 3DR Solo app

or via the Solo command line interface.

3. Follow manufacturer’s instructions to power up and calibrate

3DR Solo including instructions displayed on the Controller

4. Connect your Inexa Control PC to the 3DR Solo Wi-Fi:

Quick-Start Guide for

3DR® Solo® Quadcopter

2. Follow manufacturer’s guide to power up the controller.

MINIMUM REQUIREMENTS REQUIRED RESOURCES

 Windows 7 Professional (64-bit), Service Pack 1;

Windows 10 Pro (64-bit)

 INEXA™ Control Software Installed and licensed

 Unmanned Vehicle Plugin for ArduCopter

 Processor: Quad Core, 2.2 GHz, 6MB Cache

 ArduCopter Simulation Plugin

 Memory: 4GB DDR3 1600 MHz

 Graphics Card: 1GB GDDR5 Dedicated Memory

 DirectX 11.0

 3DR Solo with latest 3DR Officially released software and

firmware

 Dedicated Wireless Network Interface Card (for Solo)

 Storage: 64 GB

 Display Resolution: 1280 x 1024 at 96 DPI

 Online Map Service: Broadband Internet Connection separate

from vehicle specific communication hardware requirements

 Offline Map Service: ESRI ArcMap 10.1; Broadband Internet

Connection for creation of offline maps from online sources

within INEXA Control

Need help?

Do you have a question about the Insitu 3DR Solo and is the answer not in the manual?

Insitu 3DR Solo Specifications

General

Manufacturer	3D Robotics
GPS	Yes
Category	Quadcopter
Weight	1.5 kg (3.3 lbs)
Max Flight Time	20 minutes
Max Range	800 m
Camera	GoPro Compatible (GoPro not included)
Battery	5200 mAh
Operating Temperature	-10°C
Camera Mount	3-axis gimbal (optional)
Autonomous Flight Modes	Cable Cam, Orbit, Follow Me