Inspire 1 Pro User Manual

Inspire 1 Pro Release Notes
© 2017 DJI. All Rights Reserved.
2017.07.10
Overview:
1. All-in-One firmware version updated to v01.11.01.50.
2. Remote Controller firmware version updated to v1.7.80.
3. DJI GO app iOS version updated to v3.1.13.
4. DJI GO app Android version updated to v V3.1.8.
What’s New:
1. Updated No Fly Zone Management.
2. For increased safety, the flight is restricted to a height of 30 m and distance of 50 m when not
connected or logged into the app during flight, including DJI GO and all apps compatible with DJI
aircraft.
3. Optimized gimbal performance to improve its stability during flight.
4. Optimized the Remote Controller to match the latest aircraft firmware.
Notes:
1. Make sure to update your aircraft and gimbal before updating the Remote Controller.
2. Make sure you restart both the aircraft and remote controller after updating them to the latest
firmware. Otherwise, video downlink may be unstable. Re-link the aircraft with the remote controller if
they are disconnected.
3. Please note that firmware update may reset various Main Controller Settings, such as the RTH Altitude
and Maximum Flight Distance, to factory defaults. Before the update, take note of your preferred DJI
GO settings, and readjust them after the update to suit your preference.
4. Aircraft version v01.11.01.50 and camera version v01.10.01.40 should be displayed in DJI GO. The
version will only display correctly in DJI GO after connecting to the Internet when upgrade is complete.
5. Remote controller version v1.7.80 or above should be used together. Make sure you update the remote
controller to version v1.7.80 or above. Please note that this remote controller firmware cannot be
downgraded.

Inspire 1 Pro Specifications

General

Camera	Zenmuse X5
Max Service Ceiling Above Sea Level	4500 m
Max Wind Speed Resistance	10 m/s
GPS	Yes
Aircraft Type	Quadcopter
Max Ascent Speed	5 m/s
Max Descent Speed	4 m/s
Diagonal Size	559 to 581 mm
Gimbal	3-axis
Photo Resolution	16 MP
Max Transmission Distance	2 km
Battery Capacity	4500 mAh
Battery Voltage	22.2 V
Max Flight Time	15 minutes
Max Speed	22 m/s
Operating Temperature Range	-10°C to 40°C
Weight	2935 g
Sensor Size	Micro Four Thirds
Video Resolution	4K
Remote Controller Operating Frequency	2.400~2.483 GHz
Charging Temperature Range	5°C to 40°C (41°F to 104°F)

Summary

Inspire 1 Pro Firmware and App Update - July 10, 2017

Updated No Fly Zone Management

Introduces updated No Fly Zone Management features for enhanced safety and compliance.

Enhanced Flight Safety Restrictions

Flight restricted to 30m height and 50m distance when disconnected or not logged in.

Post-Update Restart and Re-linking Guidance

Advises restarting aircraft and remote controller after update to ensure stable video downlink.

Inspire 1 Pro Firmware and App Update - December 15, 2016

Optimized Flight Restriction Zone Management

Flight restriction zones for certain abandoned airports have been optimized.

Slowed Motor Stopping Time

Motor stopping time during flight has been slowed to three seconds.

Inspire 1 Pro Firmware and App Update - November 15, 2016

Zenmuse Z3 HDMI Output Optimization

Remote Controller HDMI output format optimized for video recording with the Zenmuse Z3.

Inspire 1 Pro Firmware and App Update - July 28, 2016

DJI Focus Compatibility Update

Remote controller updated for compatibility with the DJI Focus accessory.

Ground System Settings Reset

Ground System settings reset to default after firmware upgrade; restart and check settings.

Inspire 1 Pro Firmware and App Update - April 07, 2016

Enhanced Transmission Security

Improved encryption to enhance security during transmission between aircraft and controller.

Landing Gear Midair Lowering Fix

Fixed issue of landing gears lowering in midair on rare occasions.

Inspire 1 Pro Firmware and App Update - November 24, 2015

Compatible Lens List Update

Updated list of compatible lenses including Olympus 25mm/f1.8, 45mm/f1.8, and 14-42mm/f3.5-5.6 EZ.

Increased Sensor Bit-Width

Increased sensor bit-width from 10bit to 12bit for 4K and 2.7K video modes.

Follow Me Feature Release

The Waypoints feature has been optimized, and the Follow Me feature is now available.