STEP 3 (See Diagram 3)
A.) Slide a Plastic Washer (#38) onto the axle on Upper Hanger
Bracket (#14). Insert the axle through the Upper Cross Brace (#5)
from bottom. Secure it with one M8 x ½” Allen Bolt (#46), one Ø
7/8” Washer (#49), and one D-shaped Washer (#52).
B.) Slide a Plastic Washer (#38) onto the axle on Lower Hanger
Bracket (#15). Insert the axle into the Lower Cross Brace (#4) from
top.
C.) Do not tighten the Bolts until instructed to do so.
D.) Attach the Hanger Panel (#35) to the Upper Hanger Bracket.
Attach the Upper Hanger (#16) to the Hanger Panel. Align the holes.
Secure them together with three M6 x 5/8” Allen Bolts (#40) and Ø
¾” Washer (#47).
E.) Repeat Procedure D to install the Lower Hanger (#18).
F.) Attach the Middle Hanger Bracket (#19) and the Middle Hanger
(#17) to the Hanger Panel from each side. Align the holes. Secure
them together with two M6 x 5/8” Allen Bolts (#40) and Ø ¾”
Washer (#51).
G.)Securely tighten all the Bolts.
PAGE 9 6/2011
To Next Page
Loading...
