Need help?Do you have a question about the Insta-Flame PVS-1 and is the answer not in the manual?
General| Brand | Insta-Flame |
|---|---|
| Model | PVS-1 |
| Category | Ventilation Hood |
| Language | English |
Identifies the specific power venting system model and its purpose as an installation accessory.
Lists the Insta-Flame fireplace models for which this power venting system is approved for use.
Provides essential safety precautions regarding gas leaks and flammable materials.
Details the various components and parts included in the power vent system for installation and identification.
Outlines applicable codes and standards that must be consulted and followed during installation.
Specifies required minimum clearances from the vent system components to combustible surfaces.
Defines the maximum equivalent length for the vent pipe system and calculation methods.
Provides instructions on determining the proper location and requirements for the vent system's exit point.
Recommends optimal placement for the power venter fan to minimize noise and ensure proper function.
Illustrates and details minimum clearance distances from exterior surfaces for vent termination.
Covers restrictions on where the power venter can be installed within the exhaust system and how to mount it.
Specifies required clearances for the fan housing and vent pipe connections from combustible materials.
Defines maximum distance for the vent terminal from the appliance and minimum distance from the flue collar.
Details installing the vent terminal, securing the fireplace, and optional sound reducer.
Covers mounting the power venter, connecting flexible duct, and securing the system.
Explains how to seal all joints and connections in the venting system for air and water tightness.
Describes the step-by-step process of how the power venter operates in conjunction with the appliance's control system.
Illustrates the standard wiring connections for the 24 VAC control system of the power venter.
Lists the electrical ratings and properties of the power venter motor and control system.
Details the mechanical attributes of the power venter, including motor and bearing types.
Provides a list of part numbers for key components of the power venter system.
Guides on operating the appliance and performing initial checks after installation.
Details methods for verifying proper draft and detecting spillage of combustion products.
Explains how to adjust the air flow of the power venter for optimal performance and safety.
Instructions for inspecting the motor for free rotation and periodic lubrication with specified oil.
Guidance on cleaning the fan wheel and verifying the operation of the pressure switch.
Procedure to check if the inducer is correctly drawing flue products from the fireplace.
To Next Page