EasyManua.ls Logo

Instanta WA2N - Resetting Boiler Safety Controls

Instanta WA2N
5 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTANTA LIMITED
Canning Road Southport Merseyside PR9 7SN
Tel: (01704) 501114 Fax: (01704) 501115
IB27 - ISS:02 FM 36413 EMS 75807
To reset boiler safety controls;
Safety Caution: Isolate boiler from power supply
before proceeding:
Isolate from mains electrical power supply and
open tap to drain boiler down.
Remove draw-off tap (28mm spanner) and outer
case (2 screws top & bottom).
Over-Boil Safety: Push the small reset button in
the centre of the safety cut-out switch (located
next to the water inlet valve).
Boil-dry Safety: Push the small reset button
in the centre of the heating element (located
left-side of tank).
In any of these events the indicator lamp will flash red
or green or red and green. If the problem reoccurs
contact the Instanta Service Department –
01704 502911
Dripping Taps. These components are subject to
wear & tear but in the event of a tap failing
within 12 months of installation, we will be
pleased to replace the tap assembly by post.
Fitting is very simple and requires no tools.
An engineer call out is not necessary.
Accidental damage, misuse or use not in
accordance with these instructions and damage
caused by incorrect installation.
The manufacturer disclaims any liability for incidental,
or consequential damages.

Related product manuals