Need help?Do you have a question about the Instanta 1500 and is the answer not in the manual?
Connect the WRAS approved hose to the mains water supply via an isolating tap. Ensure correct pressure and hose material.
Connect the drip tray or rear overflow to a permanent waste outlet using appropriate fittings. Pipe diameter must be at least 15mm.
Your machine is supplied with a standard 3-pin bonded plug and lead with 13amp fuse.
Follow the sequence of indicator lights (Amber, Red, Green) to confirm filling, heating, and readiness. Allow 10 minutes before initial use.
Disconnect power, remove lid and tank lid, lift baffle plates, clean level sensing probes and white insulators with a non-metallic scourer.
Periodically inspect tap components for wear and tear. Keep spare tap spring and washer for emergencies.
Disconnect power, empty, cool, remove lid and baffles. Remove scale manually or with de-scaler solution, clean probes, rinse thoroughly.
Activated by excess steam due to scale, water interruption, or faulty sensor. Reset by switching off power for 10 minutes.
Activates if the boiler boils dry from scale or water starvation. Reset by isolating power and pushing the red reset button.
To Next Page
General
