Instapark PWT-07 User Manual

PWT-07
MANUAL
Digital Programmable Water Timer
Follow the instructions below to operate your Water Timer. Do
not use wrenches or pliers to tighten the tap adapter.
Specifications:
• Working Voltage: 3V (2pcs 1.5V AA alkaline batteries)
• Standby Current: <100UA
• Drive Mode: Impulse Solenoid Valve
• Working water pressure: 0.5-8bar
• Water proof level: IP66
Battery Installation:
• Remove the battery housing from the back of the timer
• Install 2 x 1.5V new alkaline batteries
Reinsert the battery housing, ensuring the grooves on the housing and
internal section match up. Once the housing is correctly in position, your
timer is ready for use.
Note: There will be a 1 to 5 seconds delay before the timer starts to work.

Instapark PWT-07 Specifications

General

Brand	Instapark
Model	PWT-07
Category	Control Unit
Language	English