23. This product has a polarized plug (one blade is
wider than the other). As a safety feature, this
plug will only fit in a polarized outlet one way. If
the plug does not fully fit in the outlet, reverse
the plug. If it still does not fit, contact a qualified
electrician for help. DO NOT attempt to defeat
this safety measure.
SAVE THESE INSTRUCTIONS.
KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE
REFERENCE AND MAKE SURE ANYONE WHO USES
THIS PRODUCT ALSO READS THIS MANUAL. READ
ALL INSTRUCTIONS BEFORE USING YOUR TURBO
IONIC DRYER.
NO ASSEMBLY REQUIRED.
GROUND FAULT CIRCUIT INTERRUPTERS
If you plan to use your TURBO Ionic Dryer in a
bathroom, install a GFCI now!
Contact your local electrician to determine which type is
best for you. Options include a portable unit that plugs
into the electrical outlet or a permanent unit installed by
your electrician. GFCI’s are now required by the National
Electrical Code for all bathrooms, garages, and outdoor
outlets.
Why install a GFCI?
A regular fuse or circuit breaker won’t protect you from
electrical shock if your dryer falls into water. Even if
the dryer switch is “OFF,” a non-GFCI outlet will lead to
electrical shock. A GFCI oers protection and can save
lives!
ALCI Safety Device
This hair dryer is provided with an Appliance Leakage
Circuit Interrupter (ALCI), a safety feature that renders
the unit inoperable under some abnormal conditions,
such as accidental immersion in water. Please use the
ALCI safety test button to make sure that it is operating
eectively before use.
1. Plug in the dryer and press the test button on plug.
2. The reset button will pop out and the appliance will
stop working.
3. Unplug the dryer and press the reset button. Then
reinsert plug into outlet.
4. If ALCI test button is not working, return dryer to
nearest service center.
5. If immersion occurs, bring unit to service center and
do not try to reset.
6. Repeat the test every time you use the device.
7. Should the unit go o and the reset button pops out
during use this may indicate a malfunction. Unplug
the unit from the outlet and allow the unit to cool.
Reinsert plug and begin use.
To Next Page
Loading...
