Intec FDC/aerofilter STC SR00180SE User Manual

INTEC 1206 SERIES-ICA-1
REVISION: B – 05/12/03 1 of 10
INSTRUCTIONS FOR
CONTINUED AIRWORTHINESS
STC SR00180SE
ENGINE INLET AIR FILTER SYSTEM
BELL 206 AND 407 SERIES HELICOPTERS
This supplement must be attached to the applicable Bell 206, A, A1, B, B1; Arrow Falcon OH58A, A+, C; Garlick
OH58A, A+, C Jet Ranger; Bell 206L1, L3, or L4 Long Ranger, Bell 407, FAA Approved Maintenance Manual when
the Engine Filtration System, P/N 1206IN1-600, 1206IN1-1600, 1206IN1-1601, 1206IN1-2600 or 1407IN1-600 is
installed in accordance with INTEC Supplemental Type Certificate (STC) SR00180SE. The information in this
manual supplements or supersedes the basic manual only in those areas listed.
THE SERVICE INFORMATION CONTAINED IN THIS DOCUMENT SUPERCEEDS THE SERVICE
INFORMATION SECTION CONTAINED IN DOCUMENT NO. 1206-EFS/SRV.

Intec FDC/aerofilter STC SR00180SE Specifications

General

Brand	Intec
Model	FDC/aerofilter STC SR00180SE
Category	Water Filtration Systems
Language	English

Summary

Introduction

General Product Information

Describes the engine filter system's design, components, and filter element function for aircraft.

Scope of ICA

Details the manual's coverage of airworthiness limitations, service instructions, and inspection procedures.

Safety Precautions

Highlights essential safety terms like WARNING, CAUTION, and NOTE for operational procedures.

Definitions and Acronyms

Lists and defines common abbreviations, acronyms, and symbols used throughout the manual.

Document Distribution and Updates

Explains how to obtain additional copies and updates for the ICA document.

Airworthiness Limitations

Inspection and Test Requirements

General Inspection Requirements

Covers basic maintenance and service requirements for safe operation and airworthiness.

Service Intervals and Operator Responsibility

Details service intervals and operator responsibility for increasing inspection frequency in severe conditions.

Filter Element Servicing

General Filter Element Servicing

Emphasizes care during handling, removal, and reinstallation to prevent element damage.

Filter Element Removal and Reinstallation

Provides step-by-step instructions for safely removing and reinstalling the filter element from the duct.

Filter Element Cleaning Procedures

Details cleaning methods for severe and normal conditions, including forbidden cleaning agents.

Inspection - Severe Conditions

Specifies inspection criteria for elements used in severe environments and replacement guidelines.

Inspection - Normal Conditions

Outlines inspection frequency and criteria for filter elements under normal operating conditions.

Oiling the Filter Element

Provides detailed steps and precautions for properly applying AeroFilter oil to the filter element.