4
Modifications
The FCC requires the user to be notified that any changes or
modifications made to this device that are not expressly approved
by the Manufacture may void the user’s authority to operate the
equipment.
Connections to Peripheral Devices
Connections to this device must be made with shielded cables with
metallic RFI/EMI connector hoods to maintain compliance with
FCC Rules and Regulations.
Declaration of Conformity
This device complies with Part 15 the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
European Notice
Products with the CE Marking comply with both the EMC Directive
(89/336/EEC) and the Low Voltage Directive (73/23/EEC) and
R&TTE Directive (1999/5/EC) issued by the Commission of the
European Community.
Compliance with these directives implies conformity to the
following European Norms:
• EN55022: 1998+A1: 2000+A2: 2003, CLASS B
• EN61000-3-2: 2000
• EN61000-3-3: 1995+A1: 2001
• EN55024: 1998+A1: 2001+A1: 2003
• IEC61000-4-2: 2001
• IEC61000-4-3: 2002+A1: 2002
• IEC61000-4-4: 1995+A1: 2000+A2:2001
• IEC61000-4-5: 2001
• IEC61000-4-6: 2001
• IEC61000-4-8: 2001
• IEC61000-4-11: 2001
• EN50082 (IEC801-2, IEC801-3, IEC801-4) Electro-magnetic
Immunity
To Next Page
Loading...
