Intel D845EPI - Page 14

14 Intel Desktop Boards D845EPI Quick Reference
Sie können das BIOS-Setup-Programm aufrufen, indem Sie
nach Beginn des POST-Speichertests und vor Start des
Betriebssystems die <F2> Taste drücken.
Eine vollständige Liste der BIOS-Setup-Einstellungen finden
Sie im Intel Desktop-Motherboard D845EPI Produkthandbuch
auf der Intel Express Installer CD-ROM oder gehen Sie zur Intel
World Wide Website unter
http://support.intel.com/support/motherboards/desktop/
  BIOS   
 F!   Power-On
Self-Test (POST
     
  .
   BIOS  
  Intel Desktop Board D845EPI
Product Guide"
  Intel Express Installer 
Web- Intel  
http://support.intel.com/support/motherboards/desktop/

O programa de configuração do BIOS é acessado quando a tecla
<F2> é pressionada após o início do teste de memória do POST
e antes do ínício do sistema operacional.
Para ver a lista completa das configurações do BIOS, consulte o
Guia de produto da placa de desktop Intel D845EPI no CD-
ROM Intel Express Installer ou visite o site da Intel
http://support.intel.com/support/pt/motherboards/desktop/
Se entra en el programa de configuración del BIOS pulsando la
tecla <F2> después de que comience la comprobación
automática de la memoria durante el arranque (POST) y antes de
que empiece el arranque del sistema operativo.
Para obtener una lista completa de las configuraciones del BIOS,
consulte la Guía de producto de la placa de escritorio D845EPI
en el CD-ROM de Intel Express Installer o consulte el sitio Web
de Intel en
http://support.intel.com/support/sp/motherboards/desktop/
Troubleshooting - - - - 5R]ZL ]\ZDQLHSUREOHPyZWHFKQLF]Q\FK-
Risoluzione dei problemi - Résolution de problèmes - Fehlerbehebung -
  
- Solução de problemas - Resolución de problemas
Desktop Board D845EPI system fails to boot.
• Ensure that the power supply cable with the 4-pin connector is
plugged into the 12 V processor core voltage connector
located near the processor socket on the desktop board.
• Remove and re-insert the Intel Pentium 4 processor, memory,
and any add-in cards to make sure they are fully seated.
Remove any non-essential hardware components and boot the
system.
• Disconnect all power and remove the CMOS battery. Wait 10
minutes, then re-install the battery, reconnect power, and boot
the system.
A repeating beep error code is heard and the desktop board
does not boot or show any video.
This beep code may indicate a problem during detection of the
DDR SDRAM memory device. Check to ensure that system
memory is properly installed and that the DIMMs meet the
Memory Module Requirements listed in the Supported
Components section of the Product Guide.

D845EPI 
•
4
12 V


•
Intel Pentium 4 


• CMOS 10



DDR SDRAM 
DIMM



D845EPI .
• 4
12 V
.
• Intel Pentium 4 ,
, .
.
•
CMOS .
10
, ,
, .
.
DDR SDRAM
.
, DIMM
’
’
.
D845EPI G
• 4
12 V
G
• Intel Pentium 4
G