*OUFM%FTLUPQ#PBSET%)7BOE%8/
2VJDL3FGFSFODF
5. Push the free end of the RM over the other end of the AGP connector and
press down evenly on both ends of the RM until all four tabs click
underneath the AGP connector. Do not apply unnecessary pressure to
avoid damaging the board.
OM10181
*OTUBMMJOHBO"(1$BSE
✏
/05&
5IF%)7BOE%8/CPBSETBSFPOMZDPNQBUJCMFXJUI7"(1
DBSET
Follow these instructions to install an AGP card if it has a retention notch.
1. Observe the precautions in “Before You Begin” on page 3.
2. Place the AGP card in the AGP connector.
3. Press down on the card until it is completely seated in the connector and
the card retention notch snaps into place below the RM.
4. Secure the card’s metal bracket to the chassis back panel with a screw.