Intel NUC 11 User Manual

8
NUC11ATKC2
User Guide - January 2022
3.0 Upgrade System Memory
The Intel® NUC 11 Essential Mini PC - NUC11ATKC2 has two 260-pin DDR4 SO-DIMM
memory slots
Pre-installed memory
NUC11ATKC2 4GB memory module
To upgrade memory, be sure to select memory modules that meet these requirements:
1.2V low voltage memory
 2933 MHz SO-DIMMs
 Non-ECC
 Up to 32 GB total (2x 16GB memory modules)
Find compatible system memory modules at the Intel® Product Compatibility Tool:
 NUC11ATKC2
3.1 Upgrade to Different Memory
1. Observe the precautions in "Before You Begin" in Section 1.1.
2. Turn off all peripheral devices connected to the computer.
3. Turn off the computer and disconnect the power cord.
4. Remove the computer’s bottom chassis cover.
5. Remove the pre-installed memory module
a. Gently spread the retaining clips at each end of the memory socket, which
causes the module to pop out of the socket (C).
b. Holding the module by the edges, lift it away from the socket, and
store it in an anti-static package.
6. Install the new memory modules
a. Align the small space at the bottom edge of the memory module
with the key in the socket.
b. Insert the bottom edge of the module at a 45-degree angle into
the socket (A).
c. When the module is inserted, push down on the outer edges of
the module until the retaining clips snap into place (B). Make sure
the clips are firmly in place (C).

Intel NUC 11 Specifications

General

Brand	Intel
Model	NUC 11
Category	Desktop
Language	English