Intel NUC Kit DE3815TYKHE - Open the Intel NUC Chassis; Installing and Removing Memory; Install SO-DIMMs

Intel NUC Kit DE3815TYKHE User Guide
3
This guide tells you how to:
• Install and remove memory
• Install a wireless card
• Install a 2.5” drive
• Attach the chassis stand
• Attach the VESA mount bracket
• Install an operating system
• Install the latest drivers
Open the Intel NUC Chassis
To open the Intel NUC chassis, follow these steps:
1. Unscrew the two screws (A) on the front panel of the chassis and lift the cover (B).
Installing and Removing Memory
Intel NUC Kit DE3815TYKHE has one 204-pin DDR3L SO-DIMM socket. Memory requirements:
 1.35V low voltage memory
 1066 MHz SO-DIMM
 Non-ECC
For a list of tested memory, go to the System Memory page on the Support site.
Install SO-DIMMs
To install a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.