Intel NUC8i5BEK - Open the Chassis; Installing and Removing Memory

User Guide for NUC8i5BEK, NUC8i3BEK
3
This guide tells you how to:
• Install and remove memory
• Install an M.2 SSD
• Install a VESA mount bracket
• Connect power
• Install an operating system
• Install the latest device drivers and software
Open the Chassis
Unscrew the four corner screws on the bottom of the chassis and lift the cover.
Installing and Removing Memory
Intel NUC Kits NUC8i5BEK and NUC8i3BEK have two 260-pin DDR4 SO-DIMM sockets. Memory
requirements:
 1.2V low voltage memory
 2400 MHz SO-DIMMs
 Non-ECC
Find compatible 2.5” hard drives at the Intel® Product Compatibility Tool for:
 Intel NUC Kit NUC8i5BEK
 Intel NUC Kit NUC8i3BEK
For a list of tested memory, go to the System Memory page on the Support site.