Intel NUC8i7HNK User Manual

Intel NUC Kit NUC8i7HNK & NUC8i7HVK User Guide
5
Installing and Removing Memory
The Intel NUC Kits NUC8i7HNK and NUC8i7HVK have two 260-pin DDR4 SO-DIMM sockets. Memory
requirements:
 1.2V low voltage memory
 2400 MHz SO-DIMMs
 Non-ECC
Find tested memory at the Intel® Product Compatibility Tool for:
 Intel NUC Kit NUC8i7HNK
 Intel NUC Kit NUC8i7HVK
NOTE
If only installing one SO-DIMM, install it in the lower memory socket.
To install memory, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect
the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the
retaining clips snap into place. Make sure the clips are firmly in place.
To remove memory, follow these steps:
1. Observe the precautions in “Before You Begin” on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the AC power cord from the computer.
4. Remove the computer’s cover.
5. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out of
the socket.
6. Hold the SO-DIMM by the edges, lift it away from the socket, and store it in an anti-static package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM sockets.
8. Replace the computer’s cover and reconnect the AC power cord.

Intel NUC8i7HNK Specifications

General

Brand	Intel
Model	NUC8i7HNK
Category	Desktop
Language	English