Intelbras AMT 8000 - Page 129

129
deactivate the system. Use 4 or 6 digits password, depending on the alarm center
settings.
The status request will send a four-line SMS message in the following format to
the programmed phones:
» Alarm center name: Display the alarm center's programmed name on the rst
line.
» Status: display of the alarm center Activated or Deactivated on the second line.
» Siren: display of the siren On or Off on the third line.
» Triggers: if there are triggers, the zone numbers separated by space are displayed,
if there are no triggers, nothing is displayed. Example: if there are triggers in zones
1 and 7, display on the fourth line as 01 07.
Changing the Display Name of the Alarm Center
Programming to change the display name of the alarm center, being factory
default: AMT 8000.
To change the name, enter:
1
+
Enter Active
+
00
+
Enter
+
After changing the congured value, press the Enter key. If you only want to view
the setting, press the Exit key and no programming will be changed.
6.18. Activation/deactivation of Functions
The AMT 8000 alarm center has several functions that can be activated or
deactivated according to the needs of each installation. These functions are divided
into 6 groups:
» General settings 1
» General settings 2
» Locks
» General settings 3
» Events that generate triggers
» Monitoring
General settings 1
The parameters congured in this function group are described below:
» Partitioning: with this feature, the alarm center can be divided as if it were up
to 16 independent systems. For more information, see Program or partitioning of
the central section.