20
IVP 8000 Pet sensor has a tamper key against violation, and if this key is opened/
violated, registered sirens will trigger and send the corresponding event if the
Problems that generate trigger
function is enabled (see section
Problemas que
geram disparo
). The status of the sensor communication with the alarm center will
be represented on it through the indicator LED located on the front, and when
in normal communication the LED will ash green, with partial communication
orange and no communication red (the indicator LED after 15 minutes will enter
hibernation mode for battery saving, not hindering the device communication and
to activate again press the device synchronisation key once).
3.8. Passive infrared wireless sensor - IVP 8000 Pet Cam
Dedicated accessory for checking intrusions through infrared reading in indoor
environments, in a discreet and compact way and taking into account the presence
of a pet and not triggering the alarm. It has a camera that after the sensor triggering,
sends the image of the site to the applications and software compatible with the
AMT 8000 Alarm Center. With low battery indication and sensor communication
status, supervision, activation and anti-violation system with internal tamper to
compose the 8000 line security system with maximum results.
Features
» Wireless communication with the alarm center (915 to 928 MHz) via internal
antenna, power 11 dBm.
» Communication status check through LED.
» Coverage of 12 meters by 90°.
»
Pet
function with detection ≥20 kg.
» Takes two pictures per shot. Attending therefore light and dark environments /
night period.
» Fastening by screws (not included) or double-sided tape (not included).
» DC Power Supply:2 CR123A type 3 Vdc batteries of long life lithium.
» Communication supervision and encrypted transmission.
» Range: up to 600 m with direct view in open eld.
To Next Page
Loading...
