Installation guide
IWR 3000N
Wireless router
Congratulations, you have just purchased a product with Intelbras quality and security.
Wi-Fi router Intelbras IWR 3000N provides a complete solution for home networks. With it you can
share internet access to multiple devices on a wireless network. Its installation and management
can be done through the web interface, quickly and easily.
1. Care and safety
Avoid an excessive number
of physical barriers between
the transmitting and recei-
ving devices on the Wi-Fi
network.
Adjust the antenna position:
normally the vertical position is
the most indicated.
Prefer to install your router in the
central part of the environment and
preferably in a higher location, for
example on top of a furniture.
Do not leave your router exposed to sunlight or heat sources.
Do not place the router in closed or tight places.
Do not leave your router near the microwave.
Do not leave your router near the wireless phone (analog).
2. Installation and con guration
Following, we will explain how to install and con gure your product in Router mode. If, instead,
you want to set it up as a signal repeater, see topic
2.3 Set up watching our videos on Youtube.
2.1. How to install your router
Step 1
Step 2
Step 3
Step 1: connect the computer to one of the LAN (yellow) ports on the router using a
network cable;
Note: if you wish to access your router via Wi-Fi, access the network named INTELBRAS.
Step 2: connect the network cable from the internet (for example, from your modem or
other device) to the WAN port (blue) of the router.
Step 3: connect the power supply to the router and then plug it into the electrical outlet.
The LEDs will light up.
2.2. How to con gure your router
On your computer, open your web browser (we recommend using the most current versions of Goo-
gle Chrome
®
, Mozilla Firefox
®
or Microsoft Edge
®
), and go to
http://meuintelbras.local,
as displayed
in the following image. If the page does not open, access it through
http://10.0.0.1
. This procedure
should be performed whenever you need to change any con guration of your router.
Welcome to the installation wizard! To con gure your router, follow the instructions in the
installation wizard by clicking
Start Wizard.
After starting the installation wizard, your internet connection will be recognized automati-
cally. Wait and follow the instructions.
To create your Wi-Fi network, the Wi-Fi password and the password to access your router’s
con guration page, ll in the elds shown on the screen.
Congratulations! Your router is already con gured and ready to access the Internet.
To Next Page
Need help?
General
