62
13. Set the USE OFFSET.
USE OFFSET is to determine whether the system uses OFFSET DIFF or not.
USE OFFSET and OFFSET DIFF are pair functions.
Press the UP and DOWN arrow keys to select “YES” to USE OFFSET or “NO” to
NOT USE OFFSET and press the OK key to set the USE OFFSET.
14. Set the OFFSET DIFF. (Range : ±100 )
The offset difference is to offset the signal difference between RHCP and LHCP.
Press the LEFT and RIGHT arrow keys until the desired character is underscored (selected).
Press the UP and DOWN arrow keys to increase and decrease the selected character. Or
press the NUMBER keys to set the desired value directly.
Press the OK key to set the new OFFSET DIFF.
15. Set the VERIFY TIME. (Range : 10~5000 )
The VERIFY TIME is to set the time of decoding to verify whether the signal detected is the
signal of the target satellite.
Press the LEFT and RIGHT arrow keys until the desired character is underscored (selected).
Press the UP and DOWN arrow keys to increase and decrease the selected character.
Or press the NUMBER keys to set the desired value directly.
Press the OK key to set the new VERIFY TIME.
16. Set OPERATION
Press UP and DOWN arrow keys to select OPERATION items.
USE OFFSET OFFSET DIFF.
YES -040
VERIFY TIME OPERATION
1500 SAVE
VERIFY TIME OPERATION
1500 SAVE
USE OFFSET OFFSET DIFF.
YES
-040
OPERATION*
SAVE : Save and execute the current settings.
REBOOT : The antenna will restart automatically if REBOOT ANTENNA is ON.
To Next Page
Loading...
Need help?
General
