Do not use outdoors. Keep the water purier in a dry place and
away from direct sunlight.
Unplug the power cord by pulling straight out. Do not pull on
the cord.
For household use only. This appliance is intended to be used in a household
and similar applications.
The water purier usage temperature range is between 40 F – 100 F. Lower
temperatures will aect ow rate. The water purier should also not be
installed in a location susceptible to freezing.
Do not reset the lters prematurely. Filters must be replaced to avoid
contamination of germs inside the water purier.
Do not freeze. It may cause leakage or other malfunctions. Reverse osmosis
membrane lters will be damaged below 0°C.
Do not use this product with micro-biologically unsafe water or water
from unknown sources or quality.
Do not connect the product to water inlets with water temperature
below 40 °F (4 °C) or exceeding 100 °F (38 °C).
The required working pressure of the product is 14-100 psi. If the
water pressure is lower or higher than this, install a pressure boosting
device or pressure reducing device accordingly.
Do not place anything on top of the water purier. Do not lean, shake or
push the water purier.
Do not install water purier or any parts of the water purier close to a gas
range or other combustion sources.
Do not place the water purier close to re.
It may damage to the water purier and cause re.
Do not install the water purier close to were water may splash. It may
cause electric shock or re due to an insulation deterioration.
After installing, check all water connections for leaks.
Do not connect hot water supply inlet to the water purier, hot water will
damage the RO membrane.
If water is leaking from the water purier, immediately unplug the power cord
and turn o the water valve.
Replace all the lters regularly. The lter life LED will ash when the
lter need to be changed. Please see page 5 for “General Filter
Replacement Intervals.”
Do not install close to strong magnetic elds.
Installation and removal of water purier should be done by a
plumbing professional.
If the water purier’s power cord is damaged, it must be replaced by the
manufacturer, a service agent or similarly qualied persons.
Do not clean the water purier with high water pressure equipment. It
may cause electric shock or re due to an insulation deterioration.
Before cleaning the water purier, disconnect the power cord from the outlet.
Unplug the power cord immediately and call for service if you smell
anything or hear any abnormal sounds coming from the water purier.
Service should be performed only by a certied technician.
Do not use outdoors. Keep the water purier in a dry place and away from
direct sunlight.
This system utilizes an internal water pressure pump. During a power outage, the
system will not operate. If you are aware of a scheduled power outage, or bad
weather event that might cut the power, we recommend storing water in advance.
It is normal that hear a slight noise and vibration when the water purier
is producing water. Normal sounds: vibration, water running to ll tank.
No disassembly and
repair without
permission
To Next Page