17
INTELLITEC
PDX RV LLC
Trouble Shooting
Problem
disengage (unlatch),
BD2 & BD3
. If not blown go to step 54, if
blown replace with same size fuse and retest. If fuse /
fuses re-blow go to step 54.
panel inside of RV, replace fuse, if fuse re-blows
either attempt to find damage in the harness
and repair or replace harness, (see P# 1 link
page 7). If fuse doesn’t blow then go to step 55.
than 10.5 Volts DC for the latching relay to close or
open. If batteries are below 10.5 Volts DC, charge
batteries and retest. If the batteries are charged and
are above 10.5 Volts DC go to step 56.
: The BD2 & BD3 panels have an interlock
that will not allow chassis battery bank to be
“unlatched” while ignition is on. This feature
should not be defeated as high voltages from the
alternator can damage sensitive electronics
Is engine running / ignition is on, turn engine off /
switch off ignition and retest.
If the panel fails retests then go to step 53.
Remove battery disconnect panel from cabinet /
console and with a multi-meter set on DC voltage,
measure between the blue wire at pin # 5 and the
black wire on pin # 12. The voltage should read 0
VDC, if your reading a voltage of 10.5 VDC or
greater go to step 57. If the voltage reading is 0
VDC then go to step 58.
: The BD2 & BD3 panels have an interlock
that will not allow the chassis battery bank to be
“unlatched” while ignition is on.
Disconnect the plug from the battery disconnect
panel, re-measure between the blue wire and the
black wire. If there is no voltage, replace the
battery disconnect panel, refer to PARTS LINK # 2
(page 8). If there is voltage on the blue wire, TBSH
the ignition circuit as the ignition circuit is still on
and is not being controlled by the ignition switch.
To Next Page
Loading...
