This step is already done from the factory and does not need to be done before driving.
If you for some reason need to re-bind the radio with receiver, follow these steps:
A) Mount batteries in the radio and have it powered o.
B) Insert the matching lines to the channel BIND/CH3 port of the receiver.
C) Connect the receiver battery to VCC port of the receiver and two LED are ashing which
means the receiver is put in binding mode.
D) Press the binding button on the radio and power it up.
E) Note the LED on receiver. If the LED have stopped ashing within 5 seconds
the binding was successful.
F) Remove the matching line from receiver.
G) Connect a servo to the receiver and test the function.
H) If process fails - repeat step A-F.
EN
2,4GHz radio
1. Control box
2. 2,4GHz antenna
3. Steering wheel
4. Throttle trigger
5. Battery box
6. Steering reverse
7. Power LED
8. Steering trim
9. Power switch
A. Throttle reverse
B. Power check
C. Bind
D. Dual Rate
E. Throttle trim
F. Charging input
G. DSC for simulator
LED
Matching line
Receiver
Battery
Bind radio with receiver
Problem Cause Solution
The model does not move. Radio is turned o. Turn on both radio and receiver.
Battery is not pluged in. Check batteries.
Battery is not charged. Charge the battery.
The model does not follow your
driving input.
Radio is turned o. Turn on both radio and receiver.
Reverse switches are set incorrectly. Check the reverse switches.
The radio end-point-adjustment is
set incorrectly.
Check the Dual Rate switches.
Weak batteries in model or radio. Replace batteries and charge main
battery.
The front and rear wheels rotate in
opposing directions.
The dierential are placed incorrect. Place the dierential the correct way.
Trouble shooting
Please read this section if you are having trouble with your model.
Intellitec 1/10 models comes with this radio. The radio is easy to handle and has several functions to trim the model to
suite your driving style.
To Next Page
Loading...
Need help?
General