intensity WDC-120G/WK(A) User Manual

WDC-120G/WK(A)
4 202011
noitcudortnI
1 General
1.1 Safety Precauons
Read these safety precauons carefully before installing the WDC-120G/WK(A)
General
NOTICE
Improper installaon or aachment of equipment or accessories could result in electric shock, short-circuit,
leaks, fire or other damage to the equipment. Only use accessories, oponal equipment and spare parts
made or approved by Intensity.
WARNING
Make sure installaon, tesng and applied materials comply with the applicable legislaon.
CAUTION
Wear adequate personal protecve equipment (protecve gloves, safety glasses etc.) while installing,
maintaining or servicing the system.
WARNING
Tear apart and throw away plasc packaging bags so that nobody, especially children, can play with them.
Possible risk: suffocaon.
Installaon Site
Do not install the equipment in potenally explosive environment.
Electrical
DANGER: RISK OF ELECTROCUTION
 Turn OFF all power supply before connecng electric wiring or touching electric parts.
 Disconnect the power supply for more than 1 minute and measure the voltage at the terminals of main
circuit capacitors or electrical components before servicing. The voltage must be less than 50 V DC before you
can touch electrical components. For the locaon of the terminals refer the wiring diagram.
 Do NOT touch electrical components with wet hands.
 Do NOT leave the equipment unaended when the service cover is removed.
WARNING
A main switch or other means for disconnecon, having a contact separaon in all poles providing full
disconnecon under overvoltage category III condion, shall be installed in the fixed wiring.
WARNING
 Only use copper wires.
 Make sure the field wiring complies with the applicable legislaon. Do NOT touch electrical components
with wet hands.
 All field wiring must be performed in accordance with the wiring diagram supplied with the product.
 Make sure to install earth wiring. Do NOT earth the unit to a ulity pipe, surge absorber, or telephone
earth. Incomplete earth may result in electric shock.
 Make sure to use a dedicated power circuit. NEVER use a power supply shared by another appliance.

Make sure to install the required fuses or circuit breakers.

Make sure to install an earth leakage protector. Failure to do so may cause electric shock or fire.
*Note: Install the wires at least 1 meter away from televisions or radios to prevent interference. Depending on the radio waves, a distance of 1 meter may not be sufficient.

intensity WDC-120G/WK(A) Specifications

General

Brand	intensity
Model	WDC-120G/WK(A)
Category	Controller
Language	English