Intenso XS5000 - Use; Device Overview; Operation

EN - Page 3 of 7
Device overview
USE
2. LED Status display
The current charge status of the Powerbank is displayed via the status LEDs when charging or
discharging the Powerbank.
Operation
LED light
% Energy LED 1 LED 2 LED 3 LED 4
1 % - 25 %
26 % - 50 %
51 % - 75%
76 % - 100 %
3. Commissioning / Charging the Powerbank / Charging connected devices
a) Charging the Powerbank
Please connect the supplied USB A to Type C cable with the Type C connecon (Type C In/Out) of
the Powerbank and connect the opposite end of the USB cable with the Standard USB Port of a
computer or USB power supply. You can also use a USB A to microUSB cable to charge the
Powerbank through the microUSB connecon (microUSB In). Always use only one of the two
charging opons, the Type C port (Type C In/Out) or the microUSB port (microUSB In)! The char-
ge process and the current charge status is signalled by the LED status lights. If the Powerbank is
fully charged, the LED status lights are lit permanently. The required charging me of the Power-
bank is dependent on the selected charging source and its output power (max. 5V / 2.1A).
1. Funcon key (ON/OFF)
By briey pressing the key, the current baery status is displayed through the LED lights and the
Powerbank is acvated.
If no device is connected to the Powerbank, or the connected device is fully charged, the
Powerbank changes automacally into standby mode aer a me interval of approx. 30 seconds.
2 1 3 4 5
1 - Function key (ON/OFF)
2 - USB A Out
3 - Type C In/Out
4 - microUSB In
5 - Status LEDs