Need help?Do you have a question about the Inter-m PC-800A and is the answer not in the manual?
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Input Channels | 8 |
| Channels | 8 |
| EQ per Channel | 3-band |
| USB Interface | Yes |
Describes the standard 1/4 inch phone jack for balanced or unbalanced line level signals.
Details the 3-pin XLR-type connector for balanced low impedance microphone inputs.
Explains the channel CLIP LED monitoring input circuit for clipping or overload conditions.
Details the GAIN control for adjusting input signal level and optimizing signal to noise ratio.
Covers the three-band equalizer controls for adjusting audio signal frequencies.
Details the jack for connecting to external effects devices.
Explains the jack for receiving signals from external EFX devices.
Describes the jack for applying signal directly to the built-in power amplifier.
Covers the line-level output of the SUB L bus to external equipment.
Details the line-level output of the SUB R bus to external equipment.
Explains the output that is a mix of left and right sub group outputs.
Describes the output signal from monitor sends and external monitor input.
Covers the output of the equalized signal from the 9-band equalizer.
Details the switch for selecting points monitored by LED VU indicators.
Explains the switch used to turn the AC main power on and off.
Details the switch for supplying phantom power to condenser microphones.
Describes the jacks connecting the power amplifier output to speaker systems.
Details where to plug the AC input cord into an AC outlet.
Explains the fuse holder for the AC primary fuse and replacement procedure.
Discusses the importance of proper cables and lists connector types used.
Lists input sensitivity, impedance, voltage gain, and output levels for the preamp.
Details rated output, frequency response, THD, and SNR for the main amplifier.
Provides power source, consumption, dimensions, and weight specifications.
To Next Page
