Item No. 8105082 – 12/2013 Page 1 of 6
Quick Guide - AC440 Protocol Setup
Introduction
This Quick Guide is intended to provide basic instructions on how to work with protocol setups in the AC440
module in the Affinity
2
and Callisto™ suites.
Working with Individual Setups (Test Protocols)
There are many different demands and wishes regarding how an audiometer should both function and appear
depending on the specific situation and national standards. One of the greatest advantages of the AC440
module is the flexibility, enabling you to tailor the system according to your specific preferences in the so-called
“test protocols”. Below describes basic functionality on how to work with the AC440 Protocols.
Selecting a Test Protocol:
1. Launch the Affinity
2
or Callisto™ Suite from Noah, OtoAccess™, or stand-alone.
2. Ensure you are in the AC440 screen. Click on the AUD tab if Audiometry is not the default startup screen.
3. Under Protocols and Sessions, both factory test protocols with standard/factory test parameters and
personalized test protocols can be selected.
Note: The protocols available in the drop down will depend on whether factory defaults or country specifics
defaults were chosen during the installation of the Affinity
2
or Callisto™ Suite. Therefore, certain test protocols
may be hidden. To hide or un-hide protocols, go to Menu | Setup | Show/Hide Protocols.
The AC440 Main Setup:
To Next Page
Loading...
Need help?
General
