Press the GS button on the GameShark Pro to get to the Code Generator menu while
playing a game. From there, you simply highlight the Code Generator option and press
the X button. The Code Generator menu includes several options, which include:
Option 1: Return To Game
Exits from the Code Generator menu and returns the user to the game.
Option 2: Exit To Main Menu
Returns the user to the in-game menu.
Option 3: Known Value Search
Allows the user to search through the game for all addresses with a specific value. This is
useful for finding codes for scores, money, etc. See below for further instructions.
Option 4: Unknown Value Search
For the advanced hacker, it allows the user to search through the game to try and locate
addresses without the use of specific values. This search is long, as the user may have to
search up to nine different areas of memory. Luckily once the desired address is found
most other relevant addresses are in the same basic area of memory. This search is useful
for finding codes for health meters, etc. See below for further instructions.
NOTE: If your game crashes or locks up during any of the following procedures,
simply press the RESET button on your PlayStation game console and start over
again.
KNOWN VALUE SEARCH
A known value search is used to find codes when you know the value of what you are
looking for, like "6 Lives" or "100 Bullets." To start a known search, highlight the
Known Value Search option in the Code Generator menu and press the X button.
The Known Value Search menu appears and contains these 4 commands:
Option 1: Return To Game
This will return you to the game.
Option 2: Exit To Main Menu
This takes you back to the In-Game Menu.
Option 3: Reset Code Generator
This will clear the Code Generator of all other searches that were previously performed.
Use this option when you are re-starting a search.
Option 4: Equal To
This lets you perform a search for a value that you specify.
To Next Page
Loading...