16
STILO 45
english
4. Spare parts
Only original Intercable spare parts may be used.
Battery: RA12
Battery charger: LG8
5. Conduct in case of faults
In case of any fault, the Power Tool will be switched off and remain disabled. The service
LED will glow red or orange. You can proceed with your work only after the battery has been
exchanged or removed for short time and is then re-inserted (RESET). If the malfunction
persists even after such a “reset”, please contact Intercable after-sales service.
5.1 Codes of the operating/service LED display
LED-Display Cause / remedy
after application (cycle)
steady green Working value OK
DVKLQJUHGJUHHQ Working value OK but service interval exceeded / Service
DVKLQJUHG Working value is at the limit / contact the service center
steady red Working value is outside range / return device to customer service
steady orange
Temperature is outside the tolerance range /
cool or warm the device
after power on (battery insertion)
steady green Power tool is ready for operation
steady orange
Temperature is outside the tolerance range /
cool or warm the device
steady red Battery empty / change the battery.
The fault massages can be read out using the analysis software. Please return the faulty
working diagrams to our service center.
5.2 Codes of the supply voltage LED
LED-Display Cause / remedy
after application (cycle)
DVKLQJUHG Battery charge is below 10% / Change the battery.
steady red Battery empty / change the battery.
after power on (battery insertion)
steady green Power tool is ready for operation
steady red Battery empty / change the battery.
To Next Page
Loading...