System Configuration Screen – CellCall.
The Cell Call screen is somewhat different from the Intercall screen and only shows dialogs which are
relevant to the cell call system. The system configuration screen controls global system settings, which
previously were configured using the configuration DIP switches in the L7100 Power Supply Controller. The
Day/Night Alarm Schedule is also accessed from this screen and the setup access password can be changed.
Automatic Day/Night Scheduling.
From the system screen there is a link to the Day/Night Scheduling screen which can be setup to
automatically change the system between the Day and Night alarm modes. Enter the Day Mode Start Time
and the Night Mode Start Time in 24 hour clock format and select the Enable Auto Change dialogue. The
Day/Night mode will now automatically change as the on board clock passes the times entered in this screen.
To Next Page
Loading...