Despatch Engine.
The Despatch Engine controls how events on the Intercall Network are used to drive the outputs from the
IP16, including:
• Relay Output
• RS232 Pager Output [Scope MSP Protocol]
• Other RS232 ASCII Output
Every individual entry may contain a different cause and effect process.
Every individual output is controlled with a separate despatch entry, select Click here to add a new Entry on the
despatch screen to open the Despatch Entry dialog.
Connecting the Scope Transmitter to the L7700 RS232 Port.
The Pager transmitter is connected directly to the L7700 PCB using the on-board RS232 port. The diagram
below shows the connections required. Note the CTS line is optional and may not be required – refer to
Scope/Paging equipment manual for more information
To Next Page
Loading...