Add a Despatch Entry – RELAY CONTACT OUTPUT
Every output is controlled with a despatch entry, select Click here to add a new Entry on the despatch screen to
open the Despatch Entry dialog which is shown below. In this example, we are creating a Relay Output for Attack
only for any device between 1 and 215 for any user ID and is operational in both Day and Night mode. Tick Auto
Cancel Output to clear once an Attack is no longer active. Press the Save button and the Output Despatch Entry
screen will appear shown on the right, Tick output state to set the output when this condition is true.
Press the Save button and the Output Despatch Entry screen will appear shown below, The IP16 Output is one
Normally Open Relay Contact. If you wish the contact to close for the attack condition, tick Output State. If you
wish the relay to Open for the attack leave the Output State un-ticked. You must Enable the entry in order for it to
operate. The activation of the relay can be recorded in the datalog by ticking the relevant box.
To Next Page
Loading...