Add a Despatch Entry – SCOPE PAGER OUTPUT RS232
Every type of output is controlled with a despatch entry, select Click here to add a new Entry on the
despatch screen to open the Despatch Entry dialog which is shown below. In this example, we are creating a
Serial output for Emergency only for any device between 34 and 76 for any user ID and is operational in both
Day and Night mode. Press the Save button and the Output Despatch Entry screen will appear shown at the
bottom of this page.
Press the Save button and the Serial Pager Despatch Entry screen will appear shown below. Press the Setup For
Scope button and the fields will automatically be filled. Enter the capcode you with to use with this specific entry,
tick the Entry Enabled box and press the Save button. You can manipulate the specific message sent to the pager
using the edit functions on the lower part of this screen. See the following pager and refer to the HTML for more
information. You must ensure the Serial Settings are correct and the Serial Port is enabled using the Serial
Settings dialog.
To Next Page
Loading...