Interface LCT-1 Ultimate - Checking Linearity with Weights; Applying Weights for Linearity

Interface Inc. • 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA • Phone 480.948.5555 • Fax 480.948.1924
www.interfaceforce.com • Email: contact@interfaceforce.com • ORDER TOLL-FREE 800.947.5598
10
Applying di󰀨erent weights
to check the linearity
Model LCT-1 Ultimate is being calibrated with Model SM-100 (shown above)
and the max weight is set for 100lbf (45,400gf). For Model SM-100, the
maximum zero balance is ±1.0% FS. When Model SM-100 (pictured above)
was measured, the zero balance was actually +0.25%.
In this mode, the LED flickers different colors
*Signal output when scale is empty*
Applying 800g calculates the
reading to 2.01%, and so on...