Need help?Do you have a question about the Interface LCT-1 Ultimate and is the answer not in the manual?
General| Brand | Interface |
|---|---|
| Model | LCT-1 Ultimate |
| Category | Test Equipment |
| Language | English |
Details on insulation resistance, input/output resistance, sense resistance, and A/D conversion.
Highlights include industrial connector, user-friendliness, rugged design, and alphanumeric display.
Guidance on connecting the load cell cable to the connector according to pin assignments.
Instructions for checking isolation between the load cell body and the bridge.
Procedure for turning on the Load Cell Tester by holding the ON/OFF key.
Steps to perform an initial calibration by pressing specific keys.
Select whether the load cell is 4-wire or 6-wire using the device's arrows.
Instructions to connect the screen and body pins after selecting the load cell type.
How to set the Load Cell gain using up/down arrows based on calibration certificate.
Guidance on using the default gain of 2mV/V if a calibration certificate is unavailable.
Press the Enter key to initiate the Load Cell Test (LCT) sequence.
Monitor test progress via blinking LED and confirm completion with 'END OF TEST'.
Displays the input and output resistance values of the load cell.
Shows the load cell's signal output as a percentage of its rated capacity.
Measures insulation resistance between the load cell's shield and bridge.
Measures insulation resistance between the load cell's body and bridge.
Measures insulation resistance between the load cell's shield and body.
Procedure for applying different weights to check load cell linearity.
Demonstrates linearity checks with 100g, 300g, and 800g weights and calculations.
To Next Page