Interlogix TruVision TVB-2401 Installation Guide

© 2015 United Technologies Corporation. All rights reserved. P/N 1072936-EN • REV A • ISS 26MAR15
Interlogix is part of UTC Building & Industrial Systems, a unit of United Technologies Corporation. All rights reserved.
TruVision High Definition TVI Bullet Camera
Installation Guide
Product overview
This is the Installation Guide for TruVision High Definition TVI
Bullet Camera TVB-2401/TVB-4401 and TVB-2403/TVB-4403.
This guide describes a standard installation.
Package contents:

Camera with power and
video output cables

3 screws and 3 anchors
for wall or ceiling
installation

Template

Installation Guide
• WEEE and Battery
Disposal

CD
Camera description
TVB-2401/TVB-4401
1. TVI video output cable (grey)
2. Power cable
3. Mounting base output
4. Sun shield
5. Lens
6. IR LED
TVB-2403/TVB-4403
1. WDR/CVBS switch cable
2. Power cable
3. TVI video output cable (grey)
4. CVBS video output cable
(black)
5. Mounting base
6. Sun shield
7. Lens
8. IR LED
Note:
Please check the camera output settings before setting up a
system. The TVI video output can be only connected to a DVR
with TVI signal input. The CVBS output supports the standard
monitor, test monitor, encoder and DVR.
For TVB-2403/TVB-4403, you can connect the white and black
line ends of the WDR switch cable to enable the Wide Dynamic
Range (WDR) function. The WDR function is disabled by
default. If WDR is enabled, the CVBS output will be blocked
out, and only TVI output is available.
Installation
To install the camera on a ceiling:
1. Using the template, place it level against the mounting
surface and mark the position of the mounting holes.
2. Following all local codes, drill and prepare the mounting
holes.
3. Securely fasten the mount to the mounting surface with
the screws.
5
6
4
2
1
3
7
8
6
2
1
3
4
5
Drill Template

Interlogix TruVision TVB-2401 Specifications

General

Brand	Interlogix
Model	TruVision TVB-2401
Category	Security Camera
Language	English