Interlogix PIR - User Manual

P/N 1079525 (EN) • REV A • ISS 05JUN13 1
PIR Camera Reference
Manual
Content
Contact information 1
Introduction 1
ATS1238 expander 4
Wireless PIR camera 5
Troubleshooting 6
Programming menus specific for PIR camera 7
Basic user commands 13
User menus 14
Camera diagnostics 16
Walk tests 16
Contact information
For contact information, see www.utcfireandsecurity.com or www.interlogix.com.
For customer support, see www.utcfssecurityproducts.eu.
Copyright © 2013 UTC Fire & Security Americas Corporation, Inc. All rights
reserved.
Introduction
This manual explains how to install, commission, program, and use wireless PIR
cameras together with Advisor Advanced systems.
A wireless PIR camera is a wireless PIR detector with a camera built-in. The
camera can be programmed to take pictures in case of activation of associated
zones, conditional filters, as well as by manual activation or remote requests.
After an alarm the associated pictures are sent to a central station via IP/GPRS.
Pictures can also be viewed from configuration software.

Summary

Camera Event Types

ATS1238 Expander

ATS1238 Expander Installation

Mounting the ATS1238 expander inside the Advisor Advanced large plastic housing.

ATS1238 Expander Programming

Wireless PIR Camera

Wireless PIR Camera Installation

Wireless PIR Camera Programming

Troubleshooting

Camera Busy and Error Messages

Reasons and solutions for camera busy and error messages.

Programming Menus Specific for PIR Camera

Pic Options and Settings

Camera Configuration

Camera Unregistering

Basic User Commands

Camera Control and Testing

User Menus

Camera Menu Functions

Walk Test

Camera Diagnostics

RF Signal and Range Tests

Perform RF RSSI tests and camera range tests to verify signal reception.

Interlogix PIR Specifications

General

Technology	Passive Infrared (PIR)
Detection Range	Up to 12 meters (40 feet)
Detection Angle	90°
Operating Temperature	14°F to 122°F (-10°C to 50°C)
Mounting Height	6.5 ft to 8 ft (2m to 2.4m)