PIR Camera Reference Manual 7
Solution: repeat the request after a delay of a few seconds.
Camera error message
Camera error message appears due to one of the following states:
• Processing another request for longer than 20 s (for example, reporting
pictures for previous request for this camera)
• Communication failed
Solutions:
• Repeat the request in a few minutes
• Verify power supply
• Verify communication quality
See also “Camera diagnostics” on page 16.
Programming menus specific for PIR camera
2.1 Installed remote devices
>Rkp R--x----
Exp m--?---
The Installed remote devices screen shows the status of all connected remote
keypads (1 to 8) and expanders (1 to 7).
The following statuses are shown if an ATS1238 expander is connected to the MI
bus:
• M: ATS1238 is online and configured (polled)
• m: ATS1238 is online, but not configured (new)
• c: ATS1238 is online, but its address is in conflict with another expander
To configure an expander shown as “m”, press Enter. Otherwise, solve the
connection problem.
2.2.2.n.4.09 Pic options
This menu is specific for systems with wireless PIR camera expanders.
2.2.2.n.4.09.1 Pic settings
The menu allows you to configure photo recording options separately for the
following camera event types:
• Burglar alarms
• Fire alarms
• Panic alarms
• Medical alarms
To Next Page
Loading...
