Interlogix PIR - Basic User Commands; Camera Control and Testing

PIR Camera Reference Manual 13
4.3.n.7 Remote pics
7 Remote pics
>Yes<
If remote picture triggering is enabled, you can take a picture remotely, using
configuration software.
4.3.n.8 Test pic to CS
1>CS 1
------------
The command allows you to take picture and send it to a selected central station.
Choose a central station to send the picture.
Calling CS 1...
Transmitting
The current picture transmission status is shown in the bottom line of the screen.
9.1.n.4.4 Vid dest port
4 Vid dest port
>9000<
The destination port is used to send the pictures to a host.
9.1.n.4.5 Encryption
5 Encryption
>No<
If the Encryption option is set to Yes, the pictures are sent encrypted with AES
algorithm.
9.3.n.10 Max Pics 24h
10 Max Pics 24h
> <
You can limit the maximum number of pictures sent to users via GPRS or IP
transmission path during a 24-hour period.
If the limit is reached, further picture requests are denied by the system and an
appropriate event is recorded in the log.
There is no limit for pictures if this value is set to 0.
Basic user commands
The following main commands are available in Advisor Advanced user menu:
• Isolate camera. See “1.2.n.4 Isolate” on page 14.
• Allow remote camera control. See “1.2.n.6 Remote pics“ on page 14.
• Take picture. See “1.2.n.7 Test pic to CS” on page 15.
• Delete pictures. See “1.3 Delete pics” on page 15.
• Perform a walk test. See “8.2 Walk test” on page 15.