14 PIR Camera Reference Manual
• Take a picture with a fob. Ensure the fob is programmed for making picture by
using an appropriate condition filter. See “4.3.n.3 Pics by filter” on page 11.
For more information, see Advisor Advanced Programming Manual.
User menus
The following commands are available in Advisor Advanced user menu:
1.2 Camera menu
17>Camera 17
18 Camera 18
Use camera menu to take pictures manually.
Select an appropriate camera.
1.2.n Select camera
Select an appropriate camera to configure.
1.2.n.4 Isolate
When the camera is isolated, it does not take pictures. Also, pictures cannot be
sent to the panel.
1.2.n.5 Max pics 24h
5 Max pics 24h
>Infinity<
Maximum picture number defines how many pictures can be taken by the
camera during 24 hours period of set or unset state.
The counter is reset when the area changes its set state.
The allowed range is 1 to 999, or 0 (infinity), which means unlimited number of
pictures.
If the limit is reached, the camera switches off and an appropriate event is
recorded in the log.
1.2.n.6 Remote pics
If remote picture triggering is enabled, you can take a picture remotely, using
configuration software.
To Next Page
Loading...
