PIR Camera Reference Manual 15
1.2.n.7 Test pic to CS
The command allows you to take picture and send it to a selected central station.
Choose a central station to send the picture.
Calling CS 1...
Transmitting
The current picture transmission status is shown in the bottom line of the screen.
1.3 Delete pics
1>Expander 1
------------
Delete all pictures from the wireless PIR camera expander.
Select expander, then select OK and press Enter to remove all pictures from the
selected expander.
8.2 Walk test
Walk test allows the user to test all detectors in the selected areas.
To perform the walk test:
1. Enter the menu.
The display lists all zones to be tested.
2. Walk along all detection points and make sure the detector is activated either
by walking in front of it or by opening a door or window.
Each activated zone is removed from the list on the display.
3. Return to the keypad and verify the result.
If the test is passed, the following message is displayed:
Otherwise, there still is a list of untested zones. Contact the installer if you are
unable to pass the walk test.
See “Walk test” on page 16 for more details.
To Next Page
Loading...
