4 PIR Camera Reference Manual
Application example
Figure 2 below shows an example of wireless PIR camera application.
Figure 2: Application example
(1) Intrusion zone 3, PIR camera 3
(2) Access zone 2, PIR camera 2
(3) Entry/exit zone 1, door contact
(4) Intrusion zone 5, PIR camera 5
(5) Intrusion zone 4, door/window sensor
(6) Intrusion zone 6, door/window sensor
In the example above, camera 3 (item 1) is activated not only by built-in PIR
camera, but also by zones 4 (item 5) and 2 (item 2). This makes possible taking
pictures of the intruder escape path.
ATS1238 expander
PIR Camera expands Advisor Advanced control panel inputs with 868 MHz AM
wireless transmitter sensors.
ATS1238 also supports wireless PIR cameras. For intrusion alarm events the
868 MHz AM connection is used. The additional camera video verification
functionality uses the 2.4 GHz connection.
Fob buttons can be programmed to set and unset premises, or to control relays.
For example, a fob can be used to open and close a garage door remotely.
ATS1238 supports maximum 8 wireless PIR cameras and sensors (total of 32)
and 16 fobs. ATS1238 expands the panel with 32 zones.
Note: Only one ATS1238 can be connected to the control panel. Install ATS1235
expanders to increase number of sensors and fobs.
ATS1238 requires the following ATS Advanced control panel firmware versions:
MR_022.022.0110 or later.
To Next Page
Loading...
