Interlogix PIR - Camera Event Types

PIR Camera Reference Manual 3
Camera event types
There are the following camera event types available.
• Burglar alarm. Generated by alarm, entry/exit, access, 24 H, firedoor and
keybox type zones.
• Fire alarm. Generated by fire zones.
• Panic alarm. Generated by panic zones.
• Medical alarm. Generated by medical zones.
• Tamper alarm. Generated by tamper zones.
• Fault. Generated by technical, transmission fault, aux mains fault and aux
battery fault type zones.
• Custom type 1. Generated by conditional filters of this type.
The types are assigned to conditional filters.
• Custom type 2. Generated by conditional filters of this type.
Event type details are listed in Table 1 below.
Table 1: Camera events and reporting codes
Event type
Activated by zone type [1]
SIA code [2]
Burglar alarm
1. Alarm, 2. Entry/Exit 1, 3. Access, 6. 24H, 13. Fire door,
16. Key box, 18. Entry/Exit 2
BA
Fire alarm
4. Fire
FA
Panic alarm
5. Panic
PA
Medical alarm
10. Medical
MA
Tamper alarm
7. Tamper
TA
Fault
11. Technical, 12. Transmission path fault, 14. Aux mains
fault, 15. Aux batt fault
UA
Custom type 1
Not allowed [3]
Selectable
Custom type 2
Not allowed [3]
Selectable
[1] Zones of particular types do not activate camera. These are 8. Exit terminator, 9. Keyswitch,
17. Eng. reset. When an assigned zone is one of the listed types, it is ignored when active.
[2] If the camera has been activated by a standard reporting event, another event caused by
camera activation does not occur.
Detailed codes and subevent values are described in Advisor Advanced Programming
Manual.
[3] Custom type events can only be activated by condition filters.
Each of these types can be configured in “2.2.2.n.4.09.1 Pic settings” on page 7.
Depending on camera event type, the camera can be programmed to take a
single picture or a series of pictures, in low or high resolutions.